[click image to zoom]

DC Brush Type

This group of amplifiers drive brush-type DC motors and accept an analog ± 10V command signal. DC motors are easy to set up, and excellent speed control can be obtained with the addition of a velocity feedback device.

• 18 to 75V DC or 9 to 25V DC single power supply 10A peak, 6A continuous output current
• Jumper selectable modes: Current (Torque), Velocity (Tach), Voltage, IR compensation, Analog position loop
• Comprehensive motor output short-circuit protection: Output to output, Output to ground, Output to power
• Individual continuous, peak and peak time configurable output limits Built-in capacitor allowing for long wires to the power source
• Over/under voltage shutdown Internal fast-blowing fuse for maximum safety
• No integrator windup during power-up or amplifier disabled Four quadrant regenerative operation
• Amplifier enable input and fault output Forward and reverse overtravel limits
• Conservative 100% trough hole design for high reliability Small footprint